Often asked: How To Put A Chain On A Mountain Bike?

Does it matter which way a bike chain goes on?

Some chains are directional and any logos or printed letters should face out towards the mechanic on the drive side. The process for routing the chain is the same for either master link or connecting rivet chains, just make sure to lead with outer plates if using a connecting rivet chain.

How often should I change my bike chain?

To avoid this accelerated wear of your cassette and chainrings, a general rule of thumb is to replace your bike’s chain every 2,000 miles. Mind you, this is just a starting point. No two chains will wear at exactly the same rate because no two riders treat their chains the same.

How do I know my bike chain size?

Begin by counting the number of teeth on the largest front sprocket and largest rear. These numbers are often printed right on the sprockets and cogs. Next, measure the distance between the middle of the crank bolt to the rear axle. This is also the chain stay length.

You might be interested:  FAQ: How To Grow Mountain Laurel?

Why does my chain fell off when I change gears?

Most of the time, a skipping chain is caused by cable stretch. In the first half dozen rides on a new bike your shift cables stretch the most. They can also stretch over time as you ride. Hippley explains, “It takes cable tension to open a derailleur, which shifts your chain between gears.

How do you fix a bike chain that fell off?

Lift the chain and put it back on the chain ring. Turn the pedals with your hand while lifting the rear wheel to realign the chain (as in Step 2). Bike chains are very greasy and your hands will get messy. Use a pair of latex gloves, if available, or use a twig or leaf if you can.

Does bicycle chain make a difference?

You’ll notice the difference between a 12 dollar chain and a 60 dollar chain. You won’t notice the difference between a 40 dollar chain and a 90 dollar chain. If you need to remove the chain to clean it (or the rear derailleur, etc) then it’s much easier to do.

Does a Shimano bike chain have a direction?

Each of the four plates, inner and outer, are shaped differently to act in a certain way relative to their position with the front chain rings or rear cogs as you shift up or down through the gear range. This means that the HG-X chain is directional. The Shimano CN-HG900 Chain is directional and 11-speed specific.

Can a bike chain be upside down?

Upside down is fine, as far as I know. I ran my chain with the lettering in for a while when I reinstalled it in a hurry and didn’t notice.

You might be interested:  Often asked: How Many Mountain Lions In California?

How do I know if my bike chain needs replacing?

If you are using a chain designed for ten or fewer gears, replace your chain as it nears the 0.75 percent mark. If you are using an eleven or twelve speed chain, replace your chain once it has reached 0.5 percent wear. For two-sprocket or single speed bikes, replace your chain as it reaches the 1 percent wear mark.

How often should I lube my bike chain?

If you are a frequent rider, using your bike several times throughout the week, your bicycle will benefit from a regular cleaning and lubrication of the drive chain. Bicycle Tutor recommends cleaning and lubricating your bike’s drive chain at least once every month to maintain optimal performance and protection.

How much does it cost to replace a bicycle chain?

How much does a bike chain cost to replace? Entry level chains can start off around $15.00 with more expensive and higher performance chains ranging from $25.00 to $60.00 or more. More expensive chains increase shift quality and are generally more durable as they wear.

Leave a Comment

Your email address will not be published. Required fields are marked *